Soleus Air HM5-15-30 Manual e Guia do Utilizador descarregar pdf (Página 6)

ASSEMBLY - INSTALLATION

Wall Mount Instructions



ASSEMBLY - INSTALLATION

Legs Assembly Instructions

* 2 lower brackets are optional,

to reinforce the mounted heater on the wall,

you may need to find similar accessories

and repeat the wall mount steps.

Find a suitable location to mount the heater. Be sure

there is enough space for control knob operation and

heat distribution once the mount is complete.

Mark the first screw hole on the wall.

Drill a 8mm hole into each of the two marks on the wall.

Fully insert the expandable tube plug into each hole

Tighten the screw into each expandable tube plug.

DO NOT fully tighten the screw into each tube, leave

approximately 3/8" untighten.

To mount the heater, insert the screws into their

respective bracket holes on back of the heater.

12.5"

Expandable Tube Plug x 2

3/8"

Expandable Tube Plug

Floor

40"

1. Align leg assembly with the bottom of the heater using

screw holes.

2. Secure the leg assembly to the heater using two of the

provided short screws.

3. Repeat these steps to complete the installation of

These two screw hole marks must be leveled.

Mark the second screw hole 12.5" horizontally from the

first mark.

and tap slightly with a hammer.

second leg.

Long Screw x 2

Short Screw x 4

heater before mounting the heater on the wall.

40"

16"

12.5"

Please make sure the Leg & casters are removed from

Be sure there is at least 40" between screws and

floor, 40" between screws and ceiling, 16" from the

side of each screw.

1 2 3 4 5 6 7 8 9 10

Comentários a estes Manuais

Sem comentários

Soleus Air HM5-15-30 Manual e Guia do Utilizador Página 6

Comentários a estes Manuais